connector terminal "A" and ground. If SERVICE ENGINE SOON light does
not flash when ECM end of terminal "B" wire is jumpered to ground,
check PROM/MEM-CAL for proper installation. If installed correctly,
replace ECM, using original PROM/MEM-CAL. Repeat diagnostic circuit
check. If Code 12 still does not flash, replace PROM/MEM-CAL. Replace
PROM/MEM-CAL only after replacing ECM, as PROM/MEM-CAL is not likely
to be at fault.
SUMMARY
If no faults were found while performing BASIC DIAGNOSTIC
PROCEDURES, no trouble codes (or only intermittent ones) were found
while performing DIAGNOSTIC CIRCUIT CHECK and driveability problems
exist, proceed to H - TESTS W/O CODES article in this section for
diagnosis by symptom (i.e., ROUGH IDLE, NO-START, etc.) or
intermittent diagnostic procedures.
END OF ARTICLE http://www.mitchell.narod.ru/
Hosted by uCoz